BRAKE PROPORTIONING VALVE REBUILD KITS
Posted:
Sat Oct 03, 2020 12:38 am
by monzaaddict
BRAKE PROPORTIONING VALVE REBUILD KITS
https://www.musclecarresearch.com/ Combination and Prop Proportioning Valve Bleed Bleeder Tool PV2 PV4 Tool
https://www.inlinetube.com/products/pvtool76-80 brake lines SKU:CVB7802
https://www.inlinetube.com/products/cvb7802aftermarket disc drum proportioning valve
https://www.inlinetube.com/products/pr102
Re: BRAKE PROPORTIONING VALVE REBUILD KITS
Posted:
Tue Jan 19, 2021 2:07 am
by monzaaddict
if anyone is interested in the inner workings of a combination valve
Re: BRAKE PROPORTIONING VALVE REBUILD KITS
Posted:
Tue Jan 19, 2021 2:21 am
by monzaaddict
To disassemble combination valve. 1)mount in vice and remove switch with 6 point socket. 2)Remove rear piece using 6 point socket. rear proportioning spring and valve will come out. spring is deep inside body and may need some coaxing. 3) Place combination valve body in vice so that front metering valve cap is squeezed into cavity until end cap is almost flush with valve body. This allows c clip removal. 4) With c clip removed use two flat blade screwdrivers to remove metering valve cap. grab metering valve pin with needle nose pliers and pull out. 5) use a drift pin and hammer if needed to drive safety valve shuttle switch pin out back of valve body. 6) Clean body using dremel tool and wire wheels. small internal bore can be cleaned with rifle brushes either by hand or mounted in drill. Clean with brake cleaner and compressed air.
Re: BRAKE PROPORTIONING VALVE REBUILD KITS
Posted:
Wed Jan 20, 2021 11:41 am
by monzaaddict
Parts labeled. this is a Delco Moraine combination valve.
Re: BRAKE PROPORTIONING VALVE REBUILD KITS
Posted:
Sat Jan 23, 2021 11:26 am
by monzaaddict