Page 70 of 83
Re: zeke's Monza
Posted:
Wed Sep 09, 2020 11:30 amby cjbiagi
I agree, the only thing I did not like was the double bump for the dipstick. Obviously only one will match the pan, I added a little silicon in the the area of the one not used. Obviously an attempt to make one gasket fit both styles.
Re: zeke's Monza
Posted:
Wed Sep 09, 2020 5:18 pmby zeke
Page 70 woooooo! lol
When I put the Monza pan on this engine yrs ago, I thought the rear main only has a few thousand miles on it, should be ok. Big mistake, didn't consider that it was 20 years old. doh All back together now
Re: zeke's Monza
Posted:
Fri Sep 11, 2020 9:55 pmby zeke
Short drive today, no heat soak issues and no oil on garage floor.
Re: zeke's Monza
Posted:
Sat Sep 12, 2020 6:21 pmby cjbiagi
Coming along very nicely. I just redid my exhaust tips from straight out to two shorter turn downs, really like the look.
Re: zeke's Monza
Posted:
Sat Sep 12, 2020 10:26 pmby zeke
Looks good Clyde
I'm not real keen with how low the muffler bodies ended up on mine, may make changes later. I got some bad advice and bought the wrong style. I do like the double barrel look tho and it sounds pretty awesome, I think.
Re: zeke's Monza
Posted:
Thu Sep 17, 2020 4:53 amby zeke
Cup holder version 2
Re: zeke's Monza
Posted:
Thu Sep 17, 2020 4:54 amby zeke
.
Re: zeke's Monza
Posted:
Thu Sep 17, 2020 11:17 pmby Kenova
The best cup holder I ever had wore blue jeans and no bra.
Ken
Re: zeke's Monza
Posted:
Fri Sep 18, 2020 9:29 amby cjbiagi
No eating or drinking in the Monza.
Re: zeke's Monza
Posted:
Fri Sep 18, 2020 10:21 amby hammerdown7
cjbiagi wrote:No eating or drinking in the Monza.
Haha.....good one!
Re: zeke's Monza
Posted:
Tue Sep 29, 2020 10:55 pmby zeke
Fixed
Re: zeke's Monza
Posted:
Tue Sep 29, 2020 11:00 pmby zeke
It was pretty obvious that the gas tank wasn't getting vented. Pull the cap off after a drive and could hear the tank shrink as a big blast of vapor came out filler. The liquid / vapor separator was plugged.
Re: zeke's Monza
Posted:
Tue Sep 29, 2020 11:04 pmby zeke
85 - 91 S10 Sender from Amazon, easy conversion
Re: zeke's Monza
Posted:
Tue Sep 29, 2020 11:07 pmby zeke
Dremel tool with a 1/8" carbide to make a couple notches, new sender tabs are clocked differently than H
Re: zeke's Monza
Posted:
Tue Sep 29, 2020 11:11 pmby zeke
The purge port isn't needed so I used a plastic 5/8" copper tube end cap to close it off, pressed on nice and tight. The other modification needed is for the electrical plug. I used a 4 pin trailer connector.