Loking for a way to make a cold air intake, I picked up an air filter unit from a V-6 Blazer. The outlet is just a little over 3 1/2", so the hose will be a tight fit. The lower box will need to be shortened to fit.
cold air intake A.jpg
Where the hose attaches it has a little more angle to it than I would like, meaning the whole box will need to be angled, but it shuold work OK anyway. How it is positioned in pic below, there is a least 5" below the cover.
cold air intake B.jpg
Not sure yet if I am going to cut a hole into inner fender, or below the headlight for more of a Ram-air effect. I would like to have it below headlight, just a little worried about driving in the rain. Maybe the 4 1/2" of distance from bottom of box to air filter would be enough to prevent water from getting to the air filter? Along with a few small holes in the back to let water drain out, or I might need some sort of baffles for it.
cold air intake C.jpg
Anyone know if PVC cement for plumbing will work on this plastic? I can not find mine at the moment. I did try a solvent type cement and it was a no-go. I will need to put a floor back in it after shortening, so I hope the PVC stuff works.
You do not have the required permissions to view the files attached to this post.