Moderator: Moderators
sportster96blk wrote:my don hardy headers are bent different from what you show in your pic my number one tube runs really close to tubes three and five I'm thinking you need to bend that tube up closer to three.my one tube measures one inch from three and one and a half inches from five. i would have them bolted to a block out side of car so bending dont change where the flange ends up its also easier. ill post pics later of my header bolted to a donor block. right know ive got to have my nose broke....george
meangreen73vega wrote:Looks killer! I can't wait till I get mine together...if it gets together...lol
meangreen73vega wrote:Looks great! Sorry to hear about the header dilemma continuing...I've ordered a set of Bob's mounts to see if that will fix my problems. I heard from Fernando the other day and his only two suggestions were to send them back or put them in loose and get all the bolts started and tighten them one at a time checking for clearance as I went...idk
I looked at those mags that are listed in that other thread and read that the pass side support between the body and inner fender needs to be cut out...
73astregt wrote:sorry to get off the topic of your engine woes but i was looking at your pics of the sphon control arms installed on your car. i was just reading the ebay ads for the sphon arms and the umi versions as well and they both say that the poly bushed ends should be mounted to the body to quiet road noise not the axle as you have yours. trust me you will want the bushed ends on the body side to quiet the noise. i have a set of arms from e bay that heims on both ends and it sounds like the rear is falling out of the car when you hit a small bump in the road. maybe you have allready rectified this or thier instructions have changed but ive been looking at these pics since you posted them and its been bugging the crap out of me lol! look up thier ads on ebay and see for yourself. just a friendly heads up to try saving you grief down the road good luck and get that sucker done beforwe summer so you can drive it to the monzaque!
Users browsing this forum: No registered users and 9 guests