by monzacoupe » Thu Apr 14, 2016 10:31 am
At some point in it's past, most of the top mounting tabs on the header panel have been broken off. I've come up with this...cut and bent some sheet metal to size then attached them to the panel with Construction Pl glue. I will drill out the holes needed when I get to mounting it. It's a McGyver-type solution I know, but I would like to hear any thoughts/criticisms from all.
Rick
You do not have the required permissions to view the files attached to this post.
Last edited by
monzacoupe on Fri Apr 15, 2016 10:40 am, edited 1 time in total.