Moderator: Moderators
RedFiveKBS wrote:I am trying to keep moving and updating! _______________________
The rear end is installed. It is not torqued as the manual says to do that at ride height. I will worry about that another day.
A sticky note on the dash would be good insurance, we know how these projects can get sidelined! Hopefully cheap insurance that [stalled Projectitis] doesn't happen. [Our problems are usually for issues we don't think are coming/ or we aren't prepared for.]
What a difference between when I pulled it from the car until now.________________________
The braided stainless steel hose ordered from Inline Tubes for a Monza was not 100% correct. The hose end was fine but the brass block has 7/16 fittings and the stainless steel line set I ordered from Inline Tubes has 3/8 inch fittings. It was easy enough to swap out the brass block for the correct one. If you order this hose from Inline Tubes (SH767), be sure to order one for 7/16" x 2x3/8". I used their block (TS01).
Nice! Thanx for the Heads Up!
The hose fit well after this change.
That is pretty easy on the eyes!
Users browsing this forum: No registered users and 10 guests